8. Disconnect the bottom flex-cable connector from the inverter connector on the
system board by peeling up the pull-tab and pulling the tab down and away from the
inverter connector.
1 inverter connector
2 bottom flex-cable
connector
3 pull-tab
Installing the Display Panel
1. Connect the top flex-cable connector to the display panel connector.
2. Connect the bottom flex-cable connector to the inverter connector.
3. Lay the display panel in the top cover.
4. Route the display-feed flex cable so that it rests in the notch located in the bottom
edge of the top cover.
5. Replace the eight M2 x 3-mm screws that secure the display panel to the top cover.
6. Replace the
display bezel.
file:///F|/Service%20Manuals/Dell/Inspiron/1100-5100-5150/display.htm (7 of 10) [2/28/2004 6:46:40 AM]
To Next Page
Loading...
