Dell Inspiron 13z N301Z - Camera; Removing the Camera; Replacing the Camera

Back to Contents Page
 Camera
Dell™Inspiron™M301Z/N301ZServiceManual
Removing the Camera
Replacing the Camera

Removing the Camera

1. Follow the instructions in Before You Begin.

2. Remove the display assembly (see Removing the Display Assembly).

3. Remove the display bezel (see Removing the Display Bezel).

4. Remove the two screws that secure the WLAN antenna to the display cover.

5. Disconnect the camera cable from the connector on the camera module.

6. Lift the WLAN antenna off the display panel.

7. Lift the camera module off the display cover.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
screws (2)
2
camera module
3
WLAN antenna
4
camera cable connector