Dell Inspiron 13z N301Z - Page 42


8. Turn the computer over and open the display as far as possible.

9. Remove the five screws that secure the palm rest to the system board.

10. Lift the connector latch and pull the pull-tab to disconnect the touch pad cable and the power button board cable from their connectors on the system
board.

11. Slide a plastic scribe between the computer base and the palm rest, and pry out the palm rest off the computer base.
1
power button board cable
connector
2
screws (5)
3
touch pad cable connector
CAUTION: Carefully separate the palm rest from the computer base to avoid damage to the palm rest.