Dell Inspiron 14 Intel - Replacing the Mini-Card


9. Remove the screw that secures the Mini-Card to the connector on the I/O board.

10. Lift the Mini-Card out of the I/O board connector.
Replacing the Mini-Card

1. Follow the instructions in Before You Begin.

2. Remove the new Mini-Card from its packaging.




3. Insert the Mini-Card connector at a 45-degree angle into the appropriate I/O board connector.

4. Press the other end of the Mini-Card down into the slot on the I/O board and replace the screw that secures the Mini-Card to the I/O board.

5. Connect the appropriate antenna cables to the Mini-Card you are installing. The following table provides the antenna cable color scheme for each Mini-
Card supported by your computer.
1
Mini-Card
2
securing screw
3
antenna cables (2)
CAUTION: Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector.
CAUTION: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system
board, and realign the card.
CAUTION: To avoid damage to the Mini-Card, never place cables under the card.
Connectors on the Mini-Card
Antenna Cable Color Scheme
WLAN (2 antenna cables)
