Adding and Replacing Parts 133
NOTICE: When the hard drive is not in the computer, store it in protective antistatic
packaging (see "Protecting Against Electrostatic Discharge" in the Product
Information Guide).
Replacing the Hard Drive
1
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use
excessive force, you may damage the connector.
2
Place the hard drive assembly in the hard drive bay by aligning the tabs on
the hard drive assembly with the slots in the bay and pressing the
connector end down.
3
Replace the hard drive door and tighten the screws.
4
Install the operating system for your computer, as needed (see "Restoring
Your Operating System" on page 124).
5
Install the drivers and utilities for your computer, as needed (see
"Reinstalling Drivers and Utilities" on page 122).
1 hard drive assembly 2 pull-tab
1
2
To Next Page
Loading...
