Left
1 Security-cable slot (for Noble locks)
Connect a security cable to prevent unauthorized movement of your computer.
2 Power-adapter port
Connect a power adapter to provide power to your computer and charge the
battery.
3 Network port
Connect an Ethernet (RJ45) cable from a router or a broadband modem for
network or Internet access.
4 USB 3.1 Gen 1 port with PowerShare
Connect peripherals such as external storage devices and printers.
Provides data transfer speeds up to 5 Gbps. PowerShare enables you to charge
your USB devices even when your computer is turned o.
NOTE: If the charge on your computer’s battery is less than 10 percent,
you must connect the power adapter to charge your computer, and
USB devices connected to the PowerShare port.
NOTE: If a USB device is connected to the PowerShare port before the
computer is turned o or in hibernate state, you must disconnect and
connect it again to enable charging.
NOTE: Certain USB devices may not charge when the computer is
turned o or in sleep state. In such cases, turn on the computer to
charge the device.
5 Media-card reader
Reads from and writes to media cards.
11
To Next Page
Loading...
