Replacing the speakers
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Using the alignment posts, place the speakers in the slots on the palm-
rest assembly and snap the speakers into place.
2 Route the speaker cable through the routing guides on the palm-rest
assembly.
3 Adhere the tape that secures the speaker cable to the touch-pad bracket.
4 Connect the speaker cable to the system board.
Post-requisites
1 Replace the battery.
2 Replace the base cover.
54
To Next Page
Loading...
