Replacing the subwoofer
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
NOTE: The rubber grommets may get pushed out while replacing the
sub woofers. Ensure that the rubber grommets are in their position after
placing the sub woofers on the computer base.
1 Using the alignment posts, align and place the sub woofers on the
computer base.
2 Route the sub-woofer cable through the routing guides on the computer
base.
3 Replace the rubber grommets if they are pushed up while replacing the
sub woofers.
Post-requisites
1 Follow the procedure from step 4 to step 8 in “Replacing the system
board”.
2 Replace the fans.
3 Replace the I/O board.
4 Follow the procedure from step 2 to step 6 in “Replacing the palm rest”.
5 Replace the keyboard.
6 Replace the wireless card.
7 Replace the memory modules.
8 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
9 Replace the battery.
10 Replace the base cover.
69
To Next Page
Loading...
