Removing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the wireless card.
Procedure
1 Turn the computer over and open the display to 180-degree angle.
2 Place the computer on a at surface with the display facing down.
CAUTION: Place the computer on a soft and clean surface to avoid
scratching the display.
3 Peel o the tapes that secure the display cable and touch-screen board cable to
the system board.
4 Open the latches and disconnect the display cable and the touch-screen board
cable from the system board.
5 Peel o the tape that secures the antenna cables to the keyboard shield.
57
To Next Page
Loading...
