Replacing the Optical-Drive Assembly | 19
Replacing the Optical-Drive Assembly
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 7. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Align the tabs on the optical-drive bezel with the slots on the optical drive and snap
the optical-drive bezel into place.
2 Align the screw holes on the optical-drive bracket with the screw holes on
the optical-drive assembly.
3 Replace the screws that secure the optical-drive bracket to the
optical-drive assembly.
4 Slide the optical-drive assembly into position and ensure that the screw hole on the
optical-drive bracket aligns with the screw hole on computer base.
Postrequisites
1 Follow the instructions from step 3 to step 4 in "Replacing the Memory Module(s)"
on page 15.
2 Follow the instructions in "After Working Inside Your Computer" on page 9.
OM_Book.book Page 19 Monday, October 15, 2012 10:01 PM
To Next Page
Loading...
