Dell Inspiron 1764 - Connect to the Internet (Optional)

Back to Contents Page
 Module Cover
Dell™Inspiron™1764ServiceManual
Removing the Module Cover
Replacing the Module Cover




Removing the Module Cover

1. Follow the procedures in Before You Begin.

2. Remove the battery (see Removing the Battery).

3. Loosen the three captive screws that secure the module cover to the computer base.

4. Lift the module cover up at an angle to carefully disengage it from the computer base.
Replacing the Module Cover

1. Follow the procedures in Before You Begin.

2. Align the tabs on the module cover with the slots on the computer base and gently snap the module cover into place.

3. Tighten the three captive screws that secure the module cover to the computer base.

4. Replace the battery (see Replacing the Battery).
Back to Contents Page

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as the back panel) on the computer.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
module cover
2
captive screws (3)
3
module cover tabs

