Dell Latitude LS and Inspiron 2000 Fan Removal and Replacement 7
13 Remove the two M2 x 3.5-mm screws that secure the fan to the bottom
assembly (see the Fan Removal figure).
14 Remove the fan from the bottom assembly by carefully pulling the fan wire
up out of the computer.
Replacing the Fan
1 Reconnect the fan wire to the connector on the system board assembly.
The male connector on the fan wire is keyed to fit into the female connector
one way only.
Ensure that the arrow that is stamped on top of the fan is pointing toward the
thermal cooling solution (see the following figure).
Fan Replacement
connector
fan
M2 x 8-mm
screws and
fan wire
arrow
thermal cooling solution
connector
fan
M2 x 8-mm
screws and washers (2)
fan wire
arrow
thermal cooling solution
1G133bk0.book Page 7 Friday, May 25, 2001 12:39 PM
To Next Page
Loading...
