Replacing the front I/O-panel
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Place the I/O board in the slot on the chassis.
2 Align the screw holes on the I/O board with the screw holes on the chassis.
3 Replace the two screws (#6–32 UNC 1/4'') that secure the I/O board to the
chassis.
4 Connect the I/O-board cable to the I/O board.
Post-requisites
1 Replace the front bezel.
2 Replace the computer cover.
68
To Next Page
Loading...
