164 Removing and Installing Parts
Removing the I/O Panel
NOTE: Note the routing of all cables as you remove them so that you can re-route
them correctly when installing the new I/O panel.
1
Follow the procedures in "Before You Begin" on page 105.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 107).
3
Remove the bezel (see "Removing the Bezel" on page 136).
NOTICE: When sliding the I/O panel out of the computer, be extremely careful.
Carelessness may result in damage to the cable connectors and the cable
routing clips.
4
Disconnect all the cables that are connected to the I/O panel from the
system board.
5
Remove the screw that secures the I/O panel.
6
Carefully remove the I/O panel from the computer.
1 I/O panel clamp slot 2 cables
3 I/O panel clamp 4 screw
5 I/O panel
3
5
4
2
1
book.book Page 164 Monday, October 6, 2008 11:28 AM
To Next Page
Loading...
