Removing and Installing Parts 177
6
Replace and tighten the two screws that secure the computer cover, using a
screwdriver.
7
Move the computer to the upright position.
NOTICE: To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
NOTICE: Ensure that none of the system air-vents are blocked. Blocking them
would cause serious thermal problems.
1 computer cover tab 2 slot
3 computer cover 4 front of the computer
4
3
1
2
book.book Page 177 Monday, October 6, 2008 11:28 AM
To Next Page
Loading...
