Replacing the logo board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the logo board with the slot on the chassis and replace the two screws
(M3x5) that secures the logo board to the chassis.
2 Connect the logo-board cable to the logo board.
Post-requisites
1 Replace the front cover.
2 Replace the right-side cover.
43
To Next Page
Loading...
