2. Place the processor heat sink on the system board.
3. Align the four captive screws on the processor heat sink with the screw holes on the system board and tighten the screws in sequential order (indicated
on the processor heat sink).
4. Connect the fan cable to the connector on the system board.
5. Follow the instructions from step 5 to step 17 in Replacing the System Board.
6. Replace the battery (see Replacing the Battery).
Back to Contents Page
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
