Dell Inspiron XPS - Power and Battery Safety; Air Travel and EMC Safety



Display Bezel



1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the display.
3. Remove the six rubber display bumpers and two screw covers.
4. Remove the six M2.5 x 6-mm screws and two M2.5 x 6-mm shoulder screws and remove the display bezel.

1
M2.5 x 6-mm screws (6)
5
display bezel
2
rubber display bumpers (6)
6
display panel
3
M2.5 x 6-mm shoulder screws (2)
7
display base
4
screw covers (2)
8
M2.5 x 3-mm screws (8)
CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.