6
Introduction
Re-imaging is the process of removing all software on the computer and reinstalling the
removed software. Re-imaging is required when software in the computer is corrupted
or damaged and can also be used as a means of removing harmful and malicious
software in your computer. This re-imaging guide provides the steps required for re-
imaging your computer.
CAUTION: This re-imaging guide is designed for system administrators. Do not
attempt to re-image the system if you are not an administrator or are unsure of
the procedures. Failure to follow instructions may result in permanent data loss.
NOTE: Information provided in this guide is applicable to computers with Microsoft
Windows only.
This guide assists you in installing Dell-recommended software stack and settings,
drivers, and applications, which are tested and validated on the Latitude 7390 2-in-1.
The installation of the listed drivers and applications as described in the guide enhances
the optimal performance of your computer.
Dell also provides drivers and applications that are not included with the Windows
operating system. These drivers are required to enable the following Solid State Drives
(SSD):
• 128 GB SSD
• 256 GB PCIe SSD
• 512 GB PCIe SSD
• 1024 GB PCIe SSD
It is always recommended to re-image on a newly-installed operating system and not
from any previous image-build. Ensure BIOS settings, including SATA configurations and
modes, are appropriately set and the latest drivers and applications are used when re-
imaging the computer.
To Next Page
Loading...
Need help?
General
