Information Update 7
Figure 1-1. Internal USB Connector Location
To boot from the USB memory key, you must configure the USB memory
key with a boot image and then specify the USB memory key in the boot
sequence in the System Setup program. See
"Using the System Setup
Program" in the
Hardware Owner’s Manual
. For information on creating
a bootable file on the USB memory key, see the user documentation that
accompanied the USB memory key.
NOTE: USB keys that contain multiple LUNs (Logical Unit Numbers) must be
formatted using the format utility provided by the key manufacturer.
NOTE: To avoid interference with components inside the system, the USB key must
conform to the following maximum dimensions: 11.68mm thick (0.46") x 24.89mm
width (0.98") x 66.8mm length (2.63").
1 system board 2 internal USB connector location
1
2
To Next Page
Loading...
