Dell POWEREDGE 4300 - Page 11

Dell PowerEdge 4300 System Board Upgrade Installation 9
2. Slide the system board to the right about a centimeter (half an inch) to lock the
board in place (see Figure 7).
3. Secure the system board with the thumbscrew (see Figure 7).
)LJXUH6\VWHP%RDUG,QVWDOODWLRQ
,QVWDOOL QJ6 \V WHP %R DUG &R PS RQHQ WV
To install all the components you removed from the original system board on to the
new system board, perform the following steps.
:$51,1*:KHQKDQGOLQJDQGLQVWDOOLQJPLFURSURFHVVRUVRQWKHV\VWHP
ERDUGWDNHFDUHW R DYR LG VK D US H GJ H VR Q W KH K HD W VLQ N
&$87,21,I\ RX U V\ VWH P VXS SR UW VP R UH  WKDQ  WZR PLFURSUR F HV V R UV EXW \R X
DUH R QO\LQVWDOOL Q J R Q H P LFURS UR FHVVRUHDF K R IWKHUHPDL Q LQ JPLFUR
SURF HVVR U FR Q Q HFWR U VP X VWKDYH DW H UPLQ D WR U FD UG LQ V WD OOH G
1. Install all the components you removed from the original system board (micro-
processors, terminator card[s], and DIMMs).
2. Install all internal cables to their connectors on the new system board (use the
notes you made when you removed the cables from the original system board) .
thumbscrew