Dell PowerEdge R300 - System Features

Getting Started With Your System 3
System Features
The major hardware and software features of your system include:
• 1U/1S rack-mountable chassis with support for static rails and sliding rails.
NOTE: Use the System Setup program to view processor information. See
"Using the System Setup Program" in your Hardware Owner’s Manual.
• One of the following processors:
– Single Core Intel
®
Celeron
®
445 Processor
– Dual-Core Intel Core™2 Duo E6305 or E6405 Processor
– Quad-Core Intel Xeon
®
X3323, X3353, or X3363 Processor
• A minimum of 512-MB single or dual-ranked registered 667-MHz DDR2
memory modules with ECC, upgradeable to a maximum of 24-GB by
installing combinations of 512-MB, 1-GB, 2-GB, or 4-GB memory modules
in six memory module sockets on the system board.
• One of the following riser card options:
– Two riser cards (left and center risers), each providing a x8 lane width
PCI-Express expansion slot.
OR
– One riser card (center riser), providing a x8 lane width PCI-Express
expansion slot.
– One riser card (left riser) providing a 3.3 V, 64-bit 133MHz PCI-X
expansion slot.
• One 12.7 mm DVD, or combination CD-RW/DVD in a device drive bay.
• Support for the following internal hard-drive configurations:
– Up to two 3.5-inch, internal, SATA hard drives with the optional SAS
controller card (hot-plug option available).
– Up to two 3.5-inch, internal, Serial-Attached SCSI (SAS) hard drives
with an optional SAS controller card (hot-plug option available).