k) cooling shroud/processor expansion module
5. Connect the cables to the system board, hard-drive backplane, control panel board, and the optical drive (if
applicable).
6. Route the power/data cables along the chassis wall.
7. Close the system.
8. If applicable, install the front bezel.
9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
10. Import your new or existing iDRAC Enterprise license. For more information, see
iDRAC7 User's Guide
, at dell.com/
support/manuals .
102
To Next Page
Loading...
