Dell PowerEdge R840 - User Manual

Processor Upgrade
Tech Sheet
CAUTION: Many repairs may only be done by a certified service
technician. You should only perform troubleshooting and simple repairs
as authorized in your product documentation, or as directed by the
online or telephone service and support team. Damage due to servicing
that is not authorized by Dell is not covered by your warranty. Read and
follow the safety instructions that are shipped with your product.
To install a processor
1. To install a processor remove the existing processor and heat sink
module(PHM), see the Removing a processor and heat sink module
section.
2. Install the processor and heat sink module on the processor socket, see the
Installing the new processor and heat sink module section.
Removing a processor and heat
sink module
Prerequisites
Remove the system cover and the air shroud.
For more information, refer to your system’s Installation and Service
Manual available at Dell.com/poweredgemanuals.
© 2017 Dell Inc. or its subsidiaries.
2017-09

Summary

To install a processor

Removing a processor and heat sink module

Procedure to remove the processor and heat sink module from the system, including prerequisites.

Installing the new processor and heat sink module

Procedure for installing a new processor and heat sink module into the system socket.

Dell PowerEdge R840 Specifications

General

Form Factor	2U Rack
Processor	Up to 4 x 2nd Generation Intel Xeon Scalable processors
Memory	Up to 6TB DDR4
Storage	Up to 24 x 2.5" SAS/SATA (HDD/SSD)
RAID Controller	PERC H740P
Power Supply	1100W, 1600W, or 2000W
GPU Support	Up to three double-width GPUs
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi