Dell PowerEdge R910 - Page 12

12 Information Update
Repeat step 5 through step 7 of this procedure to install the remaining
memory modules. See Table 3-1 and Table 3-2 in the Hardware Owner’s
Manual
.
8 Press the four tabs and close the memory module cover. See Figure 3.
9 Install the memory risers. See "Installing a Memory Riser" in the Hardware
Owner’s Manual
.
10 Close the system. See "Closing the System" in the Hardware Owner’s
Manual
.
11 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
12 Press <F2> to enter the System Setup program, and check the System
Memory
setting on the main System Setup screen.
13 The system should have already changed the value to reflect the newly
installed memory.
14 If the value is incorrect, one or more of the memory modules may not be
installed properly. Repeat
step 2 through step 13 of this procedure to
ensure that the memory modules are firmly seated in their sockets.
15 Run the system memory test in the system diagnostics. See "Running the
Embedded System Diagnostics" in the
Hardware Owner’s Manual .