4. Slide the control panel out of the chassis after:
– Pushing the release tab toward the front of the array in PowerVault MD3400.
– Pulling the release pin toward the front of the array in PowerVault MD3420.
Figure 20. Removing and Installing the Control Panel—PowerVault MD3400
1. control panel 2. release tab
Figure 21. Removing and Installing the Control Panel—PowerVault MD3420
1. release pin 2. control panel
Installing the Control Panel
1. Align the control panel with the slot on the array.
2. Slide the control panel into the array until:
– The release tab clicks into place in PowerVault MD3400 .
– The release pin clicks into place in PowerVaultMD3420 .
30
To Next Page
Loading...
