46 Post Installation Tasks
• Manual Discovery—Manual discovery allows you to locate
iSCSI-based storage arrays that are outside of the local sub-network.
Manual discovery requires selecting whether your storage array has a
single controller (simplex) or dual controllers (duplex) and whether to
use IPv4 or IPv6 protocol for communicating with the management
port of the storage array.
5
The next screen presents a list of the iSCSI-based storage arrays that were
discovered based on the discovery process selected in step 3.
If you select
Automatic Discovery
, the screen displays a list of all the
iSCSI-based storage arrays that were discovered in the subnet.
If you select
Manual Discovery
, then the list contains only the arrays
whose IP addresses were entered. You can add additional arrays to the list
by clicking the
Add
button on this screen.
You can also remove the arrays from this list by using the
Remove
button.
Yo u c a n c l i c k
Blink Array
to start the blinking of the array’s front panel
LED in order to locate the array physically and ensure it is the array you
intend to configure. Click
Stop Blinking
to stop the blinking of the array
before you proceed.
Select the array by clicking the radio button of the corresponding storage
array and then click
Next
.
6
Enter the name of the storage array and the password. A password is not
required during the initial configuration of the array.
If you want to set a new password for the array, select
Set Password
and
then enter the new password in the
New Password
and
Confirm New
Password
fields. Click
Next
to continue.
7
Select the IP protocol (IPv4/IPv6) to be used by the management ports. Also,
for each protocol, select whether the configuration of the management ports’
IP addresses is to be done manually or automatically. For more information,
see the
online help
.
Click
Next
to continue after selecting the protocols and the configuration
method.
If you have not selected
Specify Configuration Manually
for any of the
two protocols, then you can skip step 8.
book.book Page 46 Wednesday, December 29, 2010 9:23 PM
To Next Page
Loading...
