Post Installation Tasks 47
8
If you have selected
Specify Configuration Manually
for any of the two
protocols in the last step, a series of screens showing the backend view
image of the storage array controllers is displayed. Each image contains IP
addresses of the management ports of the controllers. Also, each image has
one management port highlighted in red.
To use an IPv4 address for the highlighted port, enter the IP address,
subnet mask and gateway address in the fields shown below the image in
order to modify it.
To use an IPv6 address for the highlighted port, enter the local IP address,
routable IP, and router IP address in the fields shown below the image in
order to modify it.
Click
Next
to continue through these images to complete the
configuration of all the management ports for the selected protocols.
9
Select the IP protocol (IPv4/IPv6) to be used by the iSCSI ports. Also, for
each protocol, select whether the configuration of the iSCSI port IP
addresses is to be done manually or automatically. For more information,
see the online help.
In the drop-down menu below the protocol section, select the appropriate
iSCSI port speed, either 1G or 10G. The selection must be based on the
supported port speeds of the devices connected to the iSCSI ports of the
storage array.
After selecting the protocols, the configuration method, and the port
speed, click
Next
to continue.
If you have not selected
Specify Configuration Manually
for either of the
two protocols, you can skip step 10.
10
If you selected
Specify Configuration Manually
for either of the two
protocols in the last step, a series of screens showing the back view image
of the storage array controllers is displayed. Each image contains IP
addresses for the iSCSI ports of the controllers. Also, each image has one
iSCSI port highlighted in red.
To use an IPv4 address for the highlighted port, enter the IP address,
subnet mask and gateway address in the fields shown below the image in
order to modify it.
book.book Page 47 Wednesday, December 29, 2010 9:23 PM
To Next Page
Loading...
