Need help?Do you have a question about the Dell PowerVault MD3820i and is the answer not in the manual?
General| HDD speed | 10000 RPM |
|---|---|
| RAID levels | 0, 1, 5, 6, 10 |
| Storage drive size | 2.5 \ |
| Storage drive capacity | 300 GB |
| Storage drive interface | Serial Attached SCSI (SAS) |
| Storage drives installed | Yes |
| Installed storage drive type | HDD |
| Supported storage drive types | HDD & SSD |
| Total installed storage capacity | 0.3 TB |
| Maximum supported storage capacity | 38.4 TB |
| Number of storage drives installed | 1 |
| Number of storage drives supported | 24 |
| Chassis type | Rack (2U) |
| Device class | - |
| Product color | Black |
| AC input voltage | 100-240 V |
| AC input frequency | 50 - 60 Hz |
| Power supply unit (PSU) capacity | 600 W |
| Operating altitude | -16 - 3048 m |
| Operating temperature (T-T) | 10 - 35 °C |
| Operating relative humidity (H-H) | 20 - 80 % |
Weight and Dimensions| Depth | 549 mm |
|---|---|
| Width | 446.3 mm |
| Height | 86.8 mm |
| Weight | 24220 g |
Unpack your system and identify each item. Assemble rails and install the system in the rack.
Connect the system's power cable(s) to the system for initial setup.
Secure the system power cable using the retention bracket and plug into an outlet.
Turn the power switch on the back of the system to the On position and verify the power LED.
Install the system bezel as shown in the figure for a clean setup.
Details on AC power supply, wattage, heat dissipation, and voltage requirements.
Physical dimensions and weight for PowerVault MD3400/MD3800 and MD3420/MD3820 series.
Environmental conditions including temperature, humidity, vibration, shock, and altitude limits.
To Next Page