Why is the DELLA 048-GM-48293 Water Dispenser making ice but not dispensing it?
The moving shaft for the ice-cubes may be blocked. Release the ice-cube button for 3 seconds, then push the “ICE” button again.
What to do if DELLA Water Dispenser shows “ ” symbol and letter “F” flashes?
This indicates a problem with the ice. It could mean there's too much ice, in which case you should remove some. Alternatively, there might be no ice inside. In that case, remove any obstacles or clean the inside wall of the ice storage. If it still doesn’t start, press "SELECT" for more than 5 seconds to run the ice making for a maximum of 10 cycles. It can also mean that the ambient temperature sensor is broken. The unit can still work, but it's recommended to call a service technician to replace the sensor. Finally, it could mean that the ice-making box cannot reset normally. In this case, call a service technician to check the problem.
Why is my DELLA Water Dispenser ice maker making no ice?
This issue can occur if the ambient or water temperature in the inner tank is too high. Ensure the ice maker operates below 90 degrees Fahrenheit and use colder water in the tank. It could also be due to refrigerant liquid leakage or a blocked pipe in the cooling system, which would require verification by a qualified technician.
How to fix ice cubes sticking together in DELLA 048-GM-48293 Water Dispenser?
If the ice cubes are sticking together, it could be because the ice cycle is too long or the water temperature in the inner tank is too low. Stop the ice maker and restart it after the ice blocks melt. Also, select the small size ice cube option. Consider changing the water in the inner tank, ensuring the water temperature is between 45-90 degrees Fahrenheit.
What to do if the “ ” symbol is lightening on and the arrow flashes on DELLA Water Dispenser?
This indicates a lack of water. Stop the ice maker, fill the water tank, and press the "ON/OFF" button again to restart the unit.
General| Brand | DELLA |
|---|---|
| Model | 048-GM-48293 |
| Category | Water Dispenser |
| Language | English |
Explains safety alert symbols, DANGER, and WARNING meanings.
General safety precautions for operating the appliance.
Identifies and describes the parts and controls of the ice maker.
Instructions for unpacking, connecting, and initial cleaning.
Steps to start the ice maker and adjust ice cube size/time.
Covers ice full status, getting ice, dispensing water, and draining.
How to set and cancel the timer for the ice maker.
Lists common issues, their causes, and recommended solutions.
Provides the electrical schematic for the ice maker.
To Next Page
