DELLA 0DH-DH50 - Pump Drain Hose Kit Installation

7
Installation Guide
Pump Drain Hose Kit Installation*
The internal pump allows the unit to operate without the need to empty water bucket.
To install the pump drain hose kit, remove the drain cap on the back of the unit.
Place the included gasket into the drain adapter. Connect the drain hose to the adapter and screw the
adapter on the back o the unit.
Lead the end of the drain hose to a nearby drain, sink, or a window up to 16” in height from the base of the
unit.
Turn on the unit and press PUMP button to enable the internal pump.
TIPS:
You may use plumber’s sealing tape (not included) for better sealing
*Only applicable to the pump model.
⚠CAUTION! WARNING: Make sure the drain hose does not tangle.
⚠CAUTION! WARNING: Placing the unit on uneven surface or improper hose installation may result in
water lling up the bucket and causing the unit the shut o.