9
User Instruction
Care and Maintenance
Clearing the water bucket:
The bucket full indicator will light up when the water bucket is full. The compressor will automatically turn
o and there will be a beeping sound.
• The unit will not function until the water bucket is empty and put back into the unit.
• The bucket should be cleaned every few weeks to prevent mold, mildew, and bacteria growth.
To remove the bucket from the unit, pull the bucket straight out.
⚠CAUTION! WARNING: When the bucket is full or removed from the machine, the compressor will turn
o, but the fan will continue to run for a few minutes.
⚠CAUTION! WARNING: Do not place a full bucket on the oor, the bottom of the bucket is uneven and
might cause spilling.
Clearing the lter:
The lter indicator will light up (after 250 hours of use) when the lter needed to be cleaned.
To remove the lter, press down the lter tabs directly above the lter and then gently pull the lter o the
unit.
Clean the lter in warm, soapy water.
Dry the lter throughly before replacing it into the unit.
Press the FILTER button to reset the indicator.
To Next Page