FEATURES
8% to 40% moisture range for alfalfa hay
8% to 23% moisture range for hops
Digital readout
Built-in calibration check
Temperature stable circuit
Ergonomic case design
Includes (1) 9-volt battery
Three year warranty
Over sixty years of proven quality, accuracy and service
BEFORE YOU BEGIN
BUTTON FUNCTIONS
Read (#1): Reads the percent moisture content value %MC.
Calibration
Check (#2) Checks the meter calibration. Displays the average of up to 100
accumulated readings; displays the highest
stored reading; erases the readings
Scale Button (#3)
Displays the meter scale (hay or hops) and acts as a toggle
switch to change between two scales. Also acts as an arrow
button when pressed after the set-point button to decrease the
set point to a lower value
Set-Point (#4): Displays the current set-point. Also acts as an arrow (scroll)
button to increase the set-point value in 1% increments.
When the battery is replaced, the meter displays its software version for
one second and then turns itself off. After replacing the battery, you
must reset the meter as described below in the “Resetting the Meter”
section.
NOTE, we recommend NOT to use a rechargeable battery and advise to
only use ‘normal but good quality’ batteries.
To Next Page
Loading...
Need help?
General
