10
only. To activate the function, press the “ECO plus” button (D).
When this function is active the appliance automatically sets
the most appropriate power level to guarantee optimum
comfort while reducing energy consumption.
While the “ECO plus” function is active, the appliance may
switch automatically to a lower heating power than the one
displayed. This may happen a number of times in an hour.
- To distribute the air ow over a wider surface, press the
swing button (F) . The appliance starts swinging to
the right and left. To stop the appliance in the desired
position, simply press the swing button (F) again.
- To turn the appliance o, press the ON/STAND-BY
button (A). The display may visualize a countdown for
about 6 seconds.
Please note: Room temperature can be displayed in
either °C or °F. To change the unit of measurement for the
temperature, press the + button for a few seconds, then
release.
Digital 24 h timer
This function can be activated from any operating mode.
Auto-start: with the appliance in STAND-BY, press the timer
button (E) . The symbol is displayed together with
the time remaining before the appliance comes on.
To adjust the timer, use the adjustment buttons + and - (B),
then wait a few seconds for the setting to be memorised.
The stand-by light (I) is displayed together with the
symbol, indicating that the timer has been set. When the
programmed time is reached, the appliance comes on with
the settings used during the previous period of operation.
Auto-o: with the appliance on, press the timer button
(E). The symbol is displayed together with the time
remaining before the appliance goes o.
To set the timer, use the adjustment buttons + and - (B),
then wait a few seconds for the setting to be memorised.
The current settings are displayed again, together with the
symbol indicating that the timer has been set.
When the programmed time is reached, the appliance goes
o automatically. To go back to operation without the timer,
press the timer button (E) twice.
The timer symbol disappears from the display.
USING THE REMOTE CONTROL
The functions on the remote control are the same as those on
the appliance control panel.
For a description of the functions, see the “Operation and use”
section on the previous page.
Inserting or replacing the batteries
The remote control is powered
by a CR2032 lithium battery.
To operate the remote control,
pull and remove the plastic
strip under the battery cover.
To replace the batteries, remove
the battery cover by sliding it as
shown in the gure.
When replacing the batteries,
make sure you respect the
polarity (see gure 2).
Replace the cover as shown in the gure.
Old batteries are harmful to the environment and must
be removed and disposed of in compliance with current
legislation.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
- To clean the lter, remove the rear grille by pulling it
outwards (g. 1).
Remove the dust lter which retains impurities in the air
drawn in from the room, blow on it lightly then replace
in the appliance.
- Never use abrasive powders or solvents to clean the
appliance.
TECHNICAL CHARACTERISTICS
Supply voltage See rating plate
Absorbed power “
Fig. 2
To Next Page
Loading...
Need help?
General