14
HOW TO DEHUMIDIFY
Dehumidifying standby/freeze
protection light
Humidistat dial
Tank full/tank
absent light
How to dehumidify
• Plug the appliance into a mains socket.
• Make sure the "tank full/tank missing" light is
off. If it is on, position the tank correctly.
• The dehumidifying standby light comes on
during the first three minutes (safety device),
then the appliance starts dehumidifying.
• The humidistat knob is used to adjust the
humidity level as desired (MIN/MED/MAX and
intermediate levels).
When the dial is on MIN, the dehumidifier
removes only a small amount of humidity
from the room. On MAX, it removes a large
amount of humidity.
To dehumidify, adjust the humidistat to one of
the positions available.
Dry mode (drying washing)
To remove a large amount of moisture (for exam-
ple when drying washing), you are recommended
to operate the appliance at maximum power by
turning the humidistat knob to DRY.
In this mode, the dehumidifier operates conti-
nuously, irrespective of the level of humidity in the
room.
To Next Page
Loading...
