DeLonghi DNS80 - Alarms and Troubleshooting; Understanding Display Alarms; Common Malfunctions and Solutions

13
7. ALARMS ON THE DISPLAY
ALARM CAUSE SOLUTION
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6 C4
The tank (A6) is missing or incorrectly
positioned
Put correctly the tank back in place (see par. “3.1
Draining into the tank”
The tank is full Empty the tank (see par. “3.1 Draining into the tank”)
B4C7
C3
C2
C1
C5
B5
B3
B2
B6
B1
C6
C4
Contact Customer Care
8. TROUBLESHOOTING
Below is a list of possible malfunctions.
If the problem cannot be resolved using the proposed solution, contact the Service Centre.
PROBLEM CAUSE SOLUTION
The appliance does not work the appliance is not plugged in plug into the mains
there is no current check the power supply
the tank is full of water position the tank correctly
the tank is incorrectly positioned
The appliance is operating in dehu-
midifying mode but the humidity does
not decrease
The lter is clogged Clean the dust lter or nano silver lter
(par. “4.2 Cleaning the dust lter”)
Either the temperature or the humidity in
the room is too low
In certain conditions it is normal for the
appliance not to dehumidify: check the
operation limits of the appliance (see chap.
“6. Technical specication”). In certain cases
it is advisable to heat the room you wish to
dehumidify.