2) OPERATION OF HEATER - WITHOUT TIMER - (MANUAL)
To operate the appliance in “manual” mode, press the “ON MODE” button. To set the required
power level, proceed as follows:
press the “ON MODE" button, and then press again one or more times within 5 seconds to select
the power level, as per the following sequence:
At any time during “Manual” operation, pressing the “ON MODE” button once will display the
previously set power level for 5 seconds; after this 5 second period, the display will return to
show the current operating power.
If Maximum power has been selected, press the “ +” or ” -” button to select the desired
comfort temperature from 5 to 35°C. By pressing the “ +” or “ -” button the desired tempe-
rature (shown on the right side of the display) will increase or decrease by 1°C. Keep pushbut-
ton pressed to move through the temperature in fast mode.
This heater has Electronic Climate Control which automatically monitors and selects the ideal
power setting to maintain your chosen temperature.
If the selected temperature is higher than the actual room temperature, the appliance will start
automatically and rapidly heat the room until it reaches the selected temperature. The unit will
automatically maintain the temperature at a constant level, by switching between maximum,
medium, minimum power and OFF (If the room temperature exceeds the selected temperature
level the appliance will switch off).
If medium power level has been selected using the “ON MODE” button, the appliance will
4
To Next Page
Loading...