DeLonghi Eletta Automatic - MENU SETTINGS; Descaling

10
5. TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch
(A19) is pressed (g. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
(A7) and is collected in the drip tray (A12) underneath. Avoid
contact with splashes of water.
• To turn the appliance on, press the button (B1-g.
8). The message “Heating up, Please wait” appears on the
display (B13).
When heating is complete, the message changes to “RINSING”.
As well as heating the boiler, this also heats the internal circuits
by circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coee appears.
6. TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts
(A7). Avoid contact with splashes of water.
• To turn the appliance o, press the button (B1- g.
8).
• The message “Turning o underway Please wait” appears
on the display (B13), then, if necessary, the appliance per-
forms a rinse cycle and goes o (standby).
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
• rst turn the appliance o by pressing the button;
• release the main switch (A19) at the back of the appliance
(g. 2).
Important!
Never press the main switch while the appliance is on.
7. MENU SETTINGS
7.1 Rinsing
Use this function to deliver hot water from the coee spout (A7)
and from the cappuccino maker/hot water spout (C6), if insert-
ed, to clean and heat the appliance’s internal circuit.
Place a container with a minimum capacity of 33,38 .oz/100 ml
under the cappuccino maker/hot water spout (g. 7).
To enable the function, proceed as follows:
1. Press the MENU/ESC button (B14) to enter the menu;
2. Press < (B4) or > (B8) (g. 9) until “Rinsing” appears on
the display (B13);
3. Press the OK button (B12-g. 10): the message “Conrm?”
is displayed;
Danger of burns!
Do not leave the appliance unattended while hot water is being
delivered.
4. Press the OK button. “RINSING Please wait” is displayed;
5. After a few seconds, hot water is delivered rst from the
coee spouts (A7), then from the cappuccino maker/hot
water spout (C6) (if inserted) to heat the appliance’s inter-
nal circuit. “RINSING” is displayed, together with a progress
bar which lls gradually as preparation proceeds;
6. To stop the process press any button or wait for delivery of
water to stop automatically.
Please note!
• If the appliance is not used for more than 3-4 days, when
switched on again, we strongly recommend performing
2/3 rinses before use;
• After cleaning, it is normal for the grounds container (A10)
to contain water.
7.2 Descaling
For instructions on descaling, see section “12. DESCALING”.
7.3 Install lter
For instructions on how to install the lter, see section “14.
WATER SOFTENER FILTER”.
7.4 Replacing the water softener lter (if
installed)
For instructions on how to replace the lter, see section “14.2
Replacing the lter”.
7.5 Adjust time
To adjust the time on the display (B13), proceed as follows:
1. Press the MENU/ESC button (B14) to enter the menu;
2. Press < (B4) or > (B8) (g. 9) until “Adjust time” is
displayed;
3. Press the OK button (B12-g. 10): the hours ash on the
display;
4. Press < or > to change the hour;
5. Press the OK button to conrm. The minutes ash;
6. Press < or > to change the minutes;
7. Press the OK button to conrm.
The time is set. Press the MENU/ESC button to exit the menu.