EN
CHOICE OF PROGRAM
Press the “Mode” button until the icon is
displayed. The upper LED on the appliance be-
comes white. Then press the ”Mode” and ”-”
buttons together and hold them both down
for at least 3 seconds.
The program code (P1, P2, P3 and P4) flashes.
Press the “+” and “-” buttons to set the pro-
gram. Press the “Mode” button to confirm.
The temperature displayed is always the “Comfort“ tempera-
ture, regardless of the currently selected “Pilot Wire” mode.
If the Pilot Wire programmer is not connected, “Comfort”
operating mode is selected automatically.
4.4.2 COMFORT
The “Comfort“ temperature set point is the temperature de-
sired by the user.
Press the “Mode“ selection key until the icon
appears on the LCD.
On the appliance the upper LED turns blue.
Select the desired temperature set point by
using the “+“ and “-“ keys.
The temperature can be choosen in the inter-
val between 7°C and 32°C.
4.4.3 NIGHT
In “Night“ mode the temperature set point must not be
higher than “Comfort“ temperature set point. If the “Comfort”
temperature is set below the “Night” temperature, the latter
will be automatically adjusted accordingly.
Press the “Mode“ selection key until the icon
appears on the LCD.
On the appliance the upper LED turns yellow.
Select the desired temperature set point by
using the “+“ and “-“ keys.
The use of this operating mode is recommended in night-
time hours and in case no people is in the room for more
than 2 hours.
4.4.4 ANTI-FREEZE
In “Anti-freeze“ mode the temperature set point is fixed at
7°C. The appliance starts heating when room temperature
goes under 7 °C and with low energy consumption it prevents
the room temperature to reach the freezing point.
Press the “Mode“ selection key until the icon
appears on the LCD.
On the appliance the upper LED turns green
and flashing.
This operating mode is recommended when no people is in
the room for more than 1 day.
4.4.5 CHRONO
In “Chrono” mode, you can select one of the three preset
chrono-thermostat programs or the custom program. The
latter lets you set various temperatures (”Comfort” and
”Night”) over a 24 hour period for each day of the week.
PROGRAM P1
HOURS MODE
FROM MONDAY TO FRIDAY
0 - 6 Night
6 - 9 Comfort
9 - 16 Night
16 - 23 Comfort
23 - 0 Night
SATURDAY AND SUNDAY
0 - 7 Night
7 - 23 Comfort
23 - 0 Night
PROGRAM P2
HOURS MODE
FROM MONDAY TO SUNDAY
0 - 7 Night
7 - 23 Comfort
23 - 0 Night
PROGRAM P3
HOURS MODE
FROM MONDAY TO FRIDAY
0 - 6 Night
6 - 9 Comfort
9 - 13 Night
13 - 23 Comfort
23 - 0 Night
SATURDAY AND SUNDAY
0 - 7 Night
7 - 23 Comfort
23 - 0 Night
To Next Page
Loading...
Need help?
General