10
1. LOCATION
Place the heater on the floor beneath the coldest window in the room, or any other loca-
tion. Your heater will reduce the effect of cold drafts. The heater should not be placed
immediately below a power outlet. Do not use this radiator in rooms with a floor area of
less than 43 square feet (4 sq. m.).
2. CONNECTION
The radiator should be connected to a properly polarized household outlet in perfect
working condition. Keep loose clothing or bedding, furniture and flammable material
away from the heater’s wall outlet.
3. TURNING ON
Turn the thermostat clockwise to its maximum position. Push down both switches. (The
switch lights stay on independently of the thermostat cycling). When room reaches the
desired temperature, turn the thermostat knob counter-clockwise very slowly and carefully
until you hear a click. This should set your heater to maintain the current temperature by
cycling on and off as required.
4. USE OF THERMOSTAT
The thermostat operates according to room air temperature, rather than radiator tempe-
rature. Turning it counter-clockwise to smaller numbers would decrease the temperature;
clockwise to greater numbers would increase the temperature.
Antifreeze function
Turn the thermostat dial to the position and push both switches on. The appliance will
maintain a minimum room temperature of approximately 5°C, thus preventing freezing
while conserving energy.
REMINDER
To completely shut the heater off, ON/OFF both switches must be set in the OFF position.
5. COMFORTEMP FUNCTION
With both switches ON and the COMFORTEMP button depressed the appliance is auto-
matically set to reach and maintain the suggested & preset ideal energy-saving tempera-
ture. When operating in COMFORTEMP mode, the half-circle green pilot light is on. To
quit the COMFORTEMP function and return to manual operation, depress the COMFOR-
TEMP button once again.
With pilot lights ON, the heater is ON!
WATTS ECONOMIZER
For more economical use, the two switches may be
used individually, after unit has reached the operating
temperature:
- button in position «l» = minimum power (indi-
cator light on);
- button in position «ll» = intermediate power
(indicator light on);
- both buttons in position «l» «ll» = maximum
power (indicator lights on)
To Next Page
Loading...
Need help?
General