11
Safety device
A safety device switches the heater off in the event of
overheating. To restart the heater, call the nearest Service
center.
6. MAINTENANCE AND SERVICE
Always unplug the heater from the power outlet and allow
the radiator to cool. Wipe radiator with a soft damp cloth;
do not use detergents and abrasives. Should the radiator
not be in use over a certain length of time, roll the cable
around the holder and store it in a dry place.
This appliance has been built to last for many years of trou-
ble-free service. In case of malfunction or doubt, do not try
to repair the heater by yourself: this might increase the risk
of fire and electric shock. Call nearest Service Center for a
complete list of Service Centers (U.S. Only).
Your product is equipped with a polarized alternating current line plug (a plug having
one blade wider than the other). There is only one way it can be plugged into a power
supply. This is a safety feature. If you are unable to insert the plug fully into the outlet,
try again by turning it the other way. If it would still not go in, it is probably due to an
obsolete outlet which should be replaced. Do not tamper with the plug or outlet to
defeat the purpose of this safety mechanism.
TROUBLESHOOTING
COMFORTEMP
BUTTON
GREEN
PILOT
LIGHT
PROBLEM
CAUSE SOLUTION
The appliance doesn’t work
• Be sure it is plugged in and
that the electrical outlet is
working.
• Check for any obstruction.
• The switches are in the OFF
position.
• The thermostat may be set too
low.
• Plug into the mains.
• Remove the obstruction. Let
the appliance cool down then
reinsert the plug into the
mains. If the appliance doe-
sn’t work please contact the
nearest service center.
• Switch on the appliance.
• Turn the thermostat to a
higher setting until the hea-
ter restarts.
To Next Page
Loading...
