9
TECHNICAL DATA
Mains voltage: 220-240V
˜
50-60Hz
Absorbed power: ICM16710 1200W
ICM16210 1000W
ICM16731 1200W
Weight: ICM16 2.3 kg
DISPOSING OF THE APPLIANCE
The appliance must not be disposed of with household
waste, but taken to an authorised waste separation
and recycling centre.
FAULT CONDITIONS
Display Description Solution
E1 Error water level Fill water tank
E2 Timeout error Descale
ELECTRICAL CONNECTION UK ONLY
A) If your appliance comes tted with a plug, it will incorpo-
rate a 13 Amp fuse. If it does not t your socket, the plug
should be cut o from the mains lead, and an appropriate
plug tted, as below.
WARNING: Very carefully dispose of the cut o plug after re-
moving the fuse: do not insert in a 13 Amp socket elsewhere
in the house as this could cause a shock hazard. With alter-
native plugs not incorporating a fuse, the circuit must be
protected by a 15 Amp fuse. If the plug is a moulded-on
type, the fuse cover must be re-tted when changing the
fuse using a 13 Amp Asta approved fuse to BS 1362. In the
event of losing the fuse cover, the plug must NOT be used
until a replacement fuse cover can be obtained from your
nearest electrical dealer. The colour of the correct replace-
ment fuse cover is that as marked on the base of the plug.
B) If your appliance is not tted with a plug, please follow the
instructins provided below:
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the
following code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead may not corre-
spond with the coloured markings identifying the terminals in
your plug, proceed as follows: The green and yellow wire must
be connected to the terminal in the plug marked with the letter
E or the earth symbol or coloured green or green and yel-
low. The blue wire must be connected to the terminal marked
with the letter N or coloured black. The brown wire must be con-
nected to the terminal marked with the letter L or coloured red.