4
The use of accessory attachments not recommended by the
appliance manufacturer may result in re, electric shock or
personal injury.
Important!
Failure to observe the warning could result in injury or damage
to the appliance.
- Take care when pouring - do not over-tilt the kettle as water
may enter into the switch mechanism.
- Close supervision is necessary when any appliance is used
near children.
- Do not operate this kettle if the mains lead or plug is
damaged, if the kettle malfunctions, or has been damaged
in any manner.
It must be returned to an authorised service agent for repair
or replacement in order to avoid hazard.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- Do not touch hot surfaces i.e. body or lid. Use handles or
knobs.
- Water can remain hot for a long time after boiling and can
present a scald hazard.
Keep the kettle and the mains lead away from the edge of
the work surface and out of the reach of children.
- Do not allow the mains lead to hang over the edge of the
table or work surface.
- Avoid contact with steam coming out of the spout when
pouring, and out of the lid or spout when relling.
- Never put the kettle, its base or cord near or on cooker, hot
plates or gas burners.
Please note:
This symbol indicates recommendations and important
information for the user.
- Remove the kettle from its power base before lling.
- Do not use the kettle for any purpose other than heating
water.
- De’Longhi will not accept any liability if the appliance is
subject to improper use, or failure to comply with these
instructions.
- Never use the kettle without its lid and lter (kettle may not
switch o).
- Position the kettle properly on the power base before
switching on.
This appliance conforms to EC Regulation 1935/2004 on
materials and articles intended to come into contact with
food.
Service and Customer Experience
• If the cord is damaged it must, for safety reasons, be repai-
red by De’Longhi or an authorised De’Longhi service agent.
• Please refer to the enclosed guarantee leaet for service
and assistance details.
Before use
•
Remove all packaging from the kettle and power base.
•
Do not let children play with them to avoid suocation
hazard.
•
Remove any labels from the outer stainless steel surfaces.
•
Remove the lter (g. 1) and wash with water (g. 2). Refer
to “Removing the scale lter”.
• Fill the kettle to ‘MAX’ level and boil.
•
The boiled water should be discarded and the kettle rinsed
out with cold water. Repeat the boil and rinse steps for at
least three times to remove any manufacturing dust, etc.
•
After the kettle has been rinsed out, re-t the lter (g. 3).
Using the kettle
With the specially designed power base and central connector,
you can now set the kettle on the base at any angle, from any
position.
• Release the cord
from the storage
base and adjust the
length by winding
around the base
to give the correct
cord length to reach
the plug socket to
be used (g. 1).
• Do not leave loose
cord hanging over the edge of work surfaces.
Filling
• Remove the kettle from the base unit before lling.
• Remove the lid and ll the kettle to the desired level.
Do not ll with less than 0.3 litre of water (min level)
to prevent the kettle running dry while in use; misuse of
this kind will shorten the life of the element.
Do not ll with more than 1.7 litres of water (max.
level).
If the kettle is overlled, there is a risk that boiling
water may overow and cause burns.
• To close the lid, push it onto the kettle body until it clicks
rmly into place.
Use
1
To Next Page
Loading...
Need help?
General
