Use
USE
Using for the rst time
• Before use, check that the appliance has not been
damaged during transport.
• Removeallpackagingfromthekettleandpowerbase.
• Removeanylabelsfromthe outersurfacesexcept the
rating label.
• Removethelter by pulling itup (g.1) and wash it
with water (g. 2) (refer to page 12 “Removing the scale
lter”).
• Fillthekettletothemaxlevelandboil.
• The boiled water should be discarded and the kettle
rinsed out with cold water. This procedure should be
carried out twice to remove any manufacturing dust,
etc.
• After the kettle has been rinsed out, ret the lter
(g.3).
Using the kettle
With the specially designed power base and central connector,
you can now set the kettle on the base at any angle, from any
position.
• Releasethecordfromthestoragebaseandadjustthe
length by winding around the base to give the correct
cord length to reach the plug socket to be used (g. 4).
• Donotleaveloosecordhangingovertheedgeofwork
surfaces.
Filling
• Removethekettlefromthebaseunitbeforelling.
• Removethelidandllthekettletothedesiredlevel.
Do not ll with less than 0.3 litres of water (min
level) to prevent the kettle running dry while in use;
misuse of this kind will shorten the life of the element.
Do not ll with more than 1.5 litres of water (max.
level).
Danger of burns!! If the kettle is overlled, there
is a risk that boiling water may overow and cause
burns.
• Toclosethelid,pushitontothekettlebodyuntilitclicks
rmly into place.
• Thewaterlevelindicatorenablesyoutoseethequantity
of water in the kettle.
Switching on
• Plugthepowerbaseintothemainssocket.
• Placethekettleonthepowerbase.
• PushtheON/OFFswitchdown(g.5)toswitchthekettle
on.
• Thepower-onindicatorlightswillilluminate.
• Thekettlewillautomaticallyswitchooncethewater
is boiled (the ON/OFF switch will click upwards and the
lights will switch o ).
• To turn the kettleo beforethe waterboils,youmay
5
2
1
3
4
en