Why is my DeLonghi Coffee Maker not making coffee?
If your DeLonghi Coffee Maker is not making coffee, it could be due to impurities detected in the internal circuits. Wait until the machine is ready for use again, and then select the beverage you want. If the problem continues, contact customer services.
Why is my DeLonghi MAGNIFICA EVO ECAM29X.2Y coffee not hot enough?
If your DeLonghi Coffee Maker isn't getting hot enough, it could be due to several reasons. First, try warming the cups by rinsing them with hot water. You can use the hot water function for this. Also, if it has been a few minutes since the last coffee was made, the internal circuits might have cooled down. Perform a rinse cycle by pressing and holding the button for a few seconds to warm them up. Check the coffee temperature setting in the settings menu and increase it if it's too low. Finally, the machine may need descaling. Carry out the descale procedure and then check and adjust the water hardness setting to match your local water supply.
Why is my DeLonghi Coffee Maker coffee weak?
If the coffee from your DeLonghi Coffee Maker is weak or not creamy enough, it could be due to a few reasons. The coffee might be ground too coarsely, so adjust the grinding level, keeping in mind that the effect will be visible after at least two coffees have been made. Also, make sure you are using coffee that is suitable for espresso machines. Lastly, the coffee might not be fresh, especially if the pack has been open for too long and has lost its taste.
What to do if my DeLonghi MAGNIFICA EVO ECAM29X.2Y Coffee Maker delivers coffee too slowly?
If the coffee is coming out of your DeLonghi Coffee Maker too slowly or drop by drop, it might be because the coffee is ground too finely. Try adjusting the grinding level; the effect will be noticeable after making at least two coffees.
How to unclog DeLonghi MAGNIFICA EVO ECAM29X.2Y coffee spouts?
If the coffee isn't coming out of one or both spouts of your DeLonghi Coffee Maker, the coffee nozzles might be blocked. Clean the nozzles with a cloth. If there are any encrusted deposits, you can remove them with a toothpick.
Why does my DeLonghi MAGNIFICA EVO ECAM29X.2Y ask for a third rinse after descaling?
If your DeLonghi Coffee Maker requests a third rinse at the end of descaling, it means the water tank wasn't filled to the MAX level during the two rinse cycles. Empty the drip tray, fill the tank up to the MAX level, and run the third rinse cycle.
Why does the milk have big bubbles in my DeLonghi Coffee Maker?
If the milk has big bubbles when using your DeLonghi Coffee Maker, it could be due to several reasons. Make sure you're using skimmed or semi-skimmed milk at refrigerator temperature (around 5°C). You might also want to try changing the brand of milk. Another possibility is that the cappuccino maker is dirty, so remove the components and clean them thoroughly. The use of vegetable beverages can also impact the result, depending on their nutritional properties.
Why does my DeLonghi MAGNIFICA EVO ECAM29X.2Y make noises when not in use?
If your DeLonghi Coffee Maker emits noises or small puffs of steam while not in use, it's likely part of its normal operation. This can happen when the machine is ready for use or has recently been turned off, and condensate is dripping into the hot vaporizer. To minimize this, empty the drip tray.
Why is my DeLonghi MAGNIFICA EVO ECAM29X.2Y Coffee Maker emitting steam from the drip tray?
If your DeLonghi Coffee Maker emits puffs of steam from the drip tray and there's water on the surface it rests on, it's likely that the drip tray grille hasn't been replaced after cleaning. Make sure to put the drip tray grille back in the drip tray.
General| Pump Pressure | 15 bar |
|---|---|
| Power | 1450 W |
| Milk Frother | Yes |
| Adjustable Coffee Strength | Yes |
| Adjustable Water Hardness | Yes |
| Adjustable Coffee Temperature | Yes |
| Programmable | Yes |
| Auto Off | Yes |
| Voltage | 220-240 V |
| Frequency | 50-60 Hz |
| Water Tank Capacity | 1.8 liters |
| Coffee Grounds Container Capacity | 14 servings |
| Model | ECAM29X.2Y |
| Color | Black |
| Type | Automatic Espresso Machine |
| Dimensions (W x D x H) | 240 x 440 x 360 mm |
Instructions for preparing coffee using whole coffee beans.
Guide to preparing coffee using pre-ground coffee.
Adjusting the coffee aroma strength.
Performing a rinse cycle to clean and heat the machine.
Recommendations for making hotter coffee.
How to adjust the coffee grinder for optimal output.
Programming the desired coffee volume.
Procedure for replacing the water softener filter.
Instructions on how to remove the water softener filter.
Configuring the water softener filter status.
Enabling or disabling audible beeps.
Adjusting the coffee brewing temperature.
Activating or deactivating energy saving modes.
Setting the water hardness level for descaling.
Configuring the automatic machine shut-off timer.
Procedure for emptying and cleaning the grounds container.
Cleaning the drip tray, grille, and condensate tray.
Cleaning the internal accessible parts of the machine.
Regular cleaning of the coffee dispensing spouts.
Step-by-step guide for removing and cleaning the infuser.
The initial phase of the descaling process.
The first rinsing cycle after descaling.
The second rinsing cycle after descaling.
Meaning of lights related to water tank presence and level.
Indicator for internal machine dirtiness.
Light indicating the infuser is not correctly seated.
Indicator light for an empty coffee bean container.
Light indicating the coffee grind is too fine.
Indicator for low water level in the tank.
Light signalling excessive pre-ground coffee.
Indicator for issues with pre-ground coffee preparation.
Light indicating an empty water circuit.
Indicator for a full grounds container.
Light indicating descaling has been interrupted.
Solutions for when the appliance does not power on.
Troubleshooting steps for coffee temperature issues.
Solutions for weak or uncreamy coffee.
Fixes for slow or dripping coffee delivery.
Resolving issues where the machine fails to produce coffee.
Solutions for blocked coffee spouts.
Troubleshooting watery coffee output.
Resolving issues with infuser extraction.
Addressing the third rinse requirement after descaling.
Solutions for frothy milk with large bubbles.
Explanation for a hot cup tray.
Understanding normal operational noises and steam.
Troubleshooting steam emission from the drip tray.
To Next Page