4KPUGYCVGTVCPMCVƜTUV
Fill water tank with fresh, drinking water. Place
cap and insert water tank to machine.
Switch machine on. Power button starts
blinking red while machine is heating up for
approx. 30 seconds. Afterwards power button
lights steady green and machine is ready.
30 sec
ON
Move lever to the right to start rinsing.
Open locking handle and insert empty capsule
holder. Close locking handle.
Place empty container under outlet.
Set the bar display to the maximum level with
the volume selector. Move lever to the left to
start rinsing.
Wait until the lever comes back to the middle
CPFGZVTCEVKQPUVQRU'ORV[CPFENGCPVJGLWI
Fill water tank with fresh, drinking water up to
max. level.
Make sure that the selection lever is in “STOP”
position. Then plug the power plug into a
mains power socket.
Wait until the lever comes back to the middle
and extraction stops. Machine stops rins-
ing and power button blinks red for about 10
seconds.
1
4
7
2
5
8
Place drip grid on drip tray. Then insert drip
tray at desired position of machine.
3
6
9
To Next Page
Loading...
Need help?
General
