2.1 SETTING THE CLOCK
•When the appliance is connected to the domestic power supply for the first time, or after a power cut,
four dashes will appear on the display (----).
In order to set the time of day, proceed as described below:
33
CHAPTER 2 – USING THE CONTROLS AND MODES
ENGLISH
Press the “Clock” key (6).
(The hours flash on display 1)
1
Set the desired time by tur-
ning the Time Adjust knob
(14).
(The hours flash on display 1)
2
Press the “Clock” key (6)
again.
(The minutes flash on display 1)
3
Set the desired minutes by tur-
ning the Time Adjust knob
(14)
(The minutes flash on display 1)
4
Press the “Clock” key (6)
again.
(The display shows the time set)
5
• If you wish to change the hour on the dial once it has been set, press the “Clock” key (6) before procee-
ding to set the new time as described above.
• It is possible to display the current time even after starting the mode set, by pressing the “Clock” key (6)
(the time is displayed for 3 seconds).
To Next Page
