23
HOW TO OPERATE THE AIR-CONDITIONER
(refer to the control panel on the opposite page)
Plug the appliance into the power socket.
The pilot lamp lights.
▼
The appliance comes on.
If not, refer to page 25.
▼
To switch off the appliance,
press the ON/OFFr push-button.
This appliance is fitted with a special safety circuit. When the compressor switches off, this circuit
prevents it from switching on again for at least 3 minutes.
▼
Press the ON/OFF key. The conditioning and sleep
pilot lamps flash and the pilot lamp switches off.
▼
Press the button for the desired function:
= Air-conditioning
= Sleep
The signal lamps AUTO, MAX, MIN are flashing. Move
the slider on the thermostat towards MAX cold and press
the fan speed key. The correct sequence is MIN, MAX,
AUTO. When the key is pressed the first time, the MIN
lamp will flash for 3 - 4 seconds and the AUTO and MAX
lamps will go out (to modify the power, press the relevant
key).
AIR-CONDITIONING
▼
▼
The SLEEP warning lamp remains on. An automatic
program is enabled. The appliance is activated at
minimum speed. Once the ideal temperature has
been reached, the appliance controls the tempe-
rature in perfect silence, ensuring that it does not
drop excessively. The PAC 36 will only restart if the
temperature exceeds levels considered healthy.
N.B: The room should always be air-conditioned
before the SLEEP function is used.
The AUTO signal lamp comes
on. The appliance will
automatically select the fan
speed according to the internal
and external ambient
conditions. In this way, the
machine will provide the correct
cooling power and operate with
the minimum noise.
▼
AUTO
The MAX signal lamp comes on.
The appliance will function at
the maximum fan speed.
▼
MAX
The MIN signal almp comes on.
The appliance will function at
the minimum fan speed.
▼
MIN
▼
SLEEP
▼
▼
▼
▼
Select the desired operating mode “with timer” or
“without timer” (see previous page).
To Next Page
Loading...
