DeLonghi PAC EX130 ECOREAL FEEL BK User Manual (English)

To Next Page

INTRODUCTION

Thank you for choosing a De’Longhi product. Please take a few

moments to read the instructions to avoid risks or damage to the

appliance.

DESCRIPTION

Description of the appliance (see page 2 - A)

A1 air outlet flap

control panel

A3 handles

A4 castors

A5 BioSilver lter

A6 air intake grille

A7 air exhaust hose housing

A8 air intake grille

A9 power cable

A10 drainage hose with cap

A11 remote control signal receiver

A12 remote control compartment

Description of the accessories (see page 2 - B)

B1 wall ange with cap

B2 air exhaust hose

B3 hose adaptor

B4 adapter for window bracket

B5 window bracket with wing nut

B6 adapter for wall mounting/window outlet

B7 window outlet

B8 remote control

B9 window bracket cap

ELECTRICAL CONNECTION

Before plugging into the mains, check the following:

• the mains voltage is the same as that indicated on the plate

on the back of the appliance;

• the socket and electrical line are sized to support the load

required;

• the socket is the proper type for the plug, otherwise, re-

place the socket;

• the socket is connected to an ecient earthing system.

The manufacturer is not responsible in the event of non-

compliance with these injury prevention standards.

The power cable must only be replaced by specialised

technicians.

USE

The instructions below will enable you to prepare your air con-

ditioner for operation as eciently as possible. Before use, make

sure the air intake and outlet grilles are unobstructed.

Please note: This appliance is provided with an auto-evapora-

tion feature for condensate removal during cooling and dehu-

midifying modes.

AIR CONDITIONING WITHOUT INSTALLATION

CASEMENT WINDOW

If you have a casement window proceed as follows:

• Fit the air exhaust hose (B2) in the relevant housing located

on the rear side of the appliance (g. 1).

• Screw the window outlet (B7) and place outside the win-

dow to exhaust the hot air (g. 2).

DOUBLEHUNG WINDOW

If you have a double-hung window proceed as follows:

• Insert and lock the adapter for window bracket (B4) into

the slot of the window bracket (B5) (g.3)

• Place the window bracket in the window sill, and extend

the bracket fully within the window frame (g. 4).

• Fix the bracket by the wing nut (g. 5) (Should the window

bracket be too large for the window the plastic can be cut

with a saw by a qualied professional).

• Insert the air exhaust hose (B2) into the adapter for win-

dow bracket (B4) and rotate it as shown in g. 6.

• In order to facilitate the tting of the air exhaust hose (B2)

in the relevant housing located on the rear side of the ap-

pliance, position the hose adapter ‘s tabs (B3) in a vertical

axis as shown in g. 7 and proceed as shown in g.1.

SLIDING WINDOWS

• Thanks to the locking wing nut, it’s possible to use the win-

dow bracket also for sliding windows. Position the bracket

vetically with the hole in the lower part so to allow a easier

installation of the exhaust hose.

AIR CONDITIONING WITH INSTALLATION

• Fit the air exhaust hose (B2) in the relevant housing located

on the rear side of the appliance (g. 1).

• Drill a hole 150 mm in an outside wall or through a window

panel. Respect the distances, dimensions and heigh of the

hole given in gure 8.

Need help?

Do you have a question about the DeLonghi PAC EX130 ECOREAL FEEL BK and is the answer not in the manual?

DeLonghi PAC EX130 ECOREAL FEEL BK Specifications

General

Cooling Capacity	13000 BTU/h
Noise Level	64 dB(A)
Weight	32 kg
Refrigerant Gas	R290
Fan Speeds	3
Type	Portable Air Conditioner
Energy Efficiency Class (Cooling)	A
Air Flow (High Speed)	350 m³/h
Suitable for Room Area up to	120 m³
Power Supply	220-240 V / 50 Hz
Operating Temperature (Cooling)	16-32°C
Operating Temperature (Heating)	5-24°C