EasyManua.ls Logo

DeLonghi PAC N100E - Troubleshooting; Common Problems and Remedies; Self-Diagnosis Codes

DeLonghi PAC N100E
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
en
Troubleshooting
NOTE:
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE
TURNING THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. (After the unit has been on its side, oil needs to return to the

and then the compressor will break down from lack of oil.)
PROBLEM CAUSE REMEDY
The air
conditioning unit does not start.
 
 
 
tripped.
 
 
 
persists contact our toll free
customer service.
The air
conditioning unit works for a short
time only.
 -
tion.
 
 
exhaust hose.
 
 
Obstructing air discharge.
 
The air
conditioner works, but does not
cool the room.
 
 
 
 
 
 
Particular odour in the room    
The air conditioner does not
operate for about 3 minutes after
turning it on
   
The alarm light Q comes on    
operations) on page 10).
IF…IS DISPLAYED, IF…IS DISPLAYED, IF…IS DISPLAYED,

...MEANS: room temperature is too low

...MEANS: room temperature is too high
“Probe Failure
(sensor damaged)
MEANS: contact your local customer service
SELF-DIAGNOSIS

display.

Related product manuals